ArcGIS ne perce pas correctement

Question

J'ai une page d'atterrissage pour les drill throughs dans mon tableau de bord Power BI. Elle contient une carte ArcGIS et un tableau de référence. <\/P> Le drill through fonctionne exactement comme il se doit. Il filtre les points sur la carte, et il filtre les valeurs dans le tableau de référence. Cependant, la carte ne se déplace pas pour correspondre aux nouvelles valeurs filtrées via le drill through. Elle reste toujours bloquée sur l'emplacement du drill through précédent, et je dois faire glisser la carte manuellement pour trouver les nouveaux points lors du drill through suivant. <\/P> Les points sur la carte se filtrent très bien, mais la carte ne se déplace pas vers les nouveaux points. Y a-t-il une solution à cela ?<\/P> <\/P> Merci.<\/P>

AlisonWebering · Answer

I am also experiencing issues with the drill-through. Here is an example I can share as I have the same issue. I start on a map where the viewer selects a state to see funding data.

I have selected Idaho, for this example.
Using the Bing map visual, the map zooms to the selected state:

Using the ArcGIS Map with a public NPS park layer added the map does not automatically go to the state that was selected. If the user interacts with the page slicer or table, then the map will update, but it frequently takes several interactions before the map will update:

Here is what the map looks like after several interactions and what the expectation is for what it should look like upon drill-through without having to interact:

KMTURNER · Answer

Unfortunately, I'm not going to be able to share any screen shots. The drill throughs are configured correctly.

In the short term, if we go to "View a list of layers on the map" button, press "Layer Options" on Coordinates, and then press "Zoom to Layer", it will take us to the correct points on the esri ArcGIS map. But this is a little bit silly, tedious, and I feel like the map should do this automatically.

NaZhang_Esri · Answer

Hi @KMTURNER!

Thanks for your question! Have you configured the Drill through correctly? Actually I'm a bit of confused about your question. Could you please share the screenshots of the steps you made and how the report responds so that I can help? Thanks!