IdentifyLayersAsync question

Question

Hi i'm in this situation,

for example if I launch the identification near the red points I get the results correctly from the red dot layer

but if I do a small zoom out and i launch the identification in the same point and at that zoom level the layer is not visible I don't get results from the layer ... is that correct?

in this case i have zero results from dot red layer

Regards Roberto

robymun · Answer

Thanks for the reply

We have about 100 layers on the map, which are active but visible at different zoom levels.

So there are no other alternatives to make a query for each single layer?

Regards Roberto

ZackAllen · Answer

For a workaround, I suggest creating a buffer using the geometry of the tapped point. Then query the features using the buffer geometry as a query parameter. You could even scale the size of the buffer using the current  scale of the map view.

robymun · Answer

hi thank you for the answer

I ask this because in the old version 10.5.2 (now we are porting to 100) this did not happen and the client asks us to identify even if the layer at a certain zoom level is not visible. It is possible to get around the problem in some way

Regards Roberto