Obtenir "Échec de liaison dans la fonction 'Mosaic Function' dans la dernière version de drone2maps

Question

Bonjour

J'ai mis à jour drone2maps vers la dernière version et maintenant je ne peux plus créer d'images orthomosaïques. Je reçois les messages suivants :

Toute aide sera grandement appréciée

Zedwards_SIPI · Answer

Has anyone tested this? I am getting these failures too. When importing control, i am selecting 6318 (Nad83 2011), as that is the XY coordinate system of my control. Similarly, for the vertical, i am choosing Nad 83 2011 meters (ellipsoid height metric). It automatically changes the Drone2Map project coordinate system to match that of the control. Any assistance here is much appreciated.

Taren_Esri · Answer

This issue is most likely due to adjusting the default assigned coordinate system in the project. When you create a Drone2Map project in 2022.x, you should leave the project coordinate system it assigns (generally a flavor of UTM). When adding GCPs collected in WGS 1984, leave/change the GCP coordinate system to WGS 1984. It will generate the output products in that previous default UTM.

JScottSires · Answer

I am now getting this same error. I am using D2M current version (2022.1.1). However, my next line in the log is another error, and different than the screen capture above, mine is: 'Failed to exectute (ApplyBlockAdjustment)."

Thanks for any insight.