Comment connecter des brins dans un Hub Terminator

Question

Bonjour,

Je teste la nouvelle version Telco Solution 1.1 et je ne parviens pas à connecter deux câbles au niveau des brins dans un Hub Terminator.

Je crée un câble de descente (1 brin) depuis le Hub Terminator. Si je clique sur le Hub Terminator et sélectionne Modify association, je ne peux pas établir une connectivité - rien ne se charge dans la partie connectivité.

Pouvez-vous m'aider à comprendre ce que je fais de mal ?

Voir la vidéo avec mon flux de travail.

Merci.

Vladimir

Anonymous User · Accepted Answer

Hi Vladimir,

With the non-spatial model, users will need to take additional steps to build connectivity associations between the cable connectors, equipment ports, or splices within the equipment.

In your video, as you zoom into the Access Hub, you will need to build some interconnections between the Fiber Connectors within Connector Groups and the Patch Panel ports within 24-Port Patch Panel, which channels the connectivity between Access and Drop Network. You need to continue expanding the containment tree from the attribute pane to see those connectors and ports.

In the Utility Network Ribbon, use the "Modify" tool within the Association tab, create the association between the pairs of ports with the equipment.

The key here is you will need to identify the right connectors or ports from the proper chassis and load them as an active item to start the junction-to-junction connection process. This is also a space where we are reserving for users and Esri partners to create customized productivity tools and UIs to assist with this workflow.

I have included more workflows in this storymap - https://storymaps.arcgis.com/stories/2b0da80ab0ff4f17bb2a2103a4095611

Hopefully, this is helpful.

Junjie

Anonymous User · Accepted Answer

Hi Vladimir,

You are getting a step closer to finish the connection!

The only change you have to make is the terminal direction for the connector has to be "Front", in our model, the backside of the fiber/coax/copper connector is always automatically connected to the strand. The "Front" side is for connections within the device.

Once you flip that direction to "Front", it will work.