Rango incorrecto de valores digitales en la salida del Ortomosaico Térmico

Question

Estoy intentando procesar un ortomosaico a partir de imágenes térmicas capturadas por una cámara Workswell WIRIS Pro. Mis imágenes están en formato TIFF radiométrico, y los valores digitales de los píxeles están en un rango aproximado de 5000 a 7000.
Sin embargo, los valores digitales de la salida del ortomosaico solo varían en un rango entre 19 y 26. Supongo que debo modificar algún parámetro de configuración para que la salida sea correcta. ¿Alguien puede ayudarme?<\/P>

Cody Benkelman · Answer

Francisco

Do those values appear to be incorrect for your project site, assuming the pixels represent temperature in degrees Celsius?   I was going to show you that you can convert temperature units to Fahrenheit under Settings

...but I assume this project is in Spain, and you'd want Celsius.  (Note if you change units, you would have to reprocess).

Were you hoping to create a mosaic showing the original pixel values, from 5000 to 7000?

Cody B

MarkBarker1 · Answer

Hi @FranciscoCáceresClavero,

We don't have any testing data for that specific camera model, but it sounds like it is processing for you and possibly also doing the thermal temperature calculation. In cases where a drone is not supported for thermal processing yet in Drone2Map the true ortho result will only be the pixel values. We are able to add support for new thermal cameras though so if you are willing to share the data I can take a look to see what might be going on with the processing. Please feel free to email me so we can setup a shared folder: mbarker@esri.com

Regards,

Mark