UPDM y Trazado de Circuitos CP

MarkCederholm

<\/HEAD>

Como parte de nuestra eventual migración a UPDM y Utility Network, nos gustaría modelar nuestros circuitos CP como subredes.  Actualmente, tenemos una clase de entidad llamada "Insulated Node" que actúa como una barrera arbitraria para un circuito CP.  ¿Cómo modelaríamos eso en nuestra migración de datos?  Realmente no veo un tipo de unión correspondiente en UPDM, a menos que quizás agregue un nuevo tipo de activo a Electro Stop (actualmente nuestro prototipo de migración asigna aisladores de extremo de soldadura a ese subtipo).  ¿Alguna sugerencia? <\/P><\/BODY><\/HTML>

TomDeWitte

Good morning Mark,

Here are a few suggestions that I hope will help you with your modeling of CP systems within the Utility Network and UPDM 2018.

1) Keep in mind that the Utility Network similar to the geometric network cannot have two assets occupy the same position in coordinate space. In the case of the Utility Network that means two assets with the same X, Y ,Z coordinate. If your Insulated Node feature is to locate the same location as a coupling, then you will have issues.

2) The UPDM model manages insulated fittings and insulated devices through attributes.  Specifically on the PipelineJunction featureclass and the PipelineDevice featureclass there is an attribute called: InsulatorDevice.  This Yes/No boolean field defines where the assets acts as a cathodically insulating device.

3) When modeling CP systems with subnetworks, you will want to create a separate Tier Group from the Pipe tiers. Then you will want to create a Tier under the new Tier group.  I usually name my Tier group: Cathodic Protection, and then name my Tier as CP System.

Hope that helps

Tom DeWitte

Technical Lead - Natural Gas Industry

Esri, Inc