Reverse geocoding points to nearest address

Question

I'm trying to find the nearest address for a series of points.  I have a parcel layer i'm trying to use for addresses.

I was able to use the Reverse Geocode (RG) function in ArcToolbox to get a start.  However, i had to use an address locator based on a street centerline file.  Upon inspection of the addresses, the addresses the RG found were linearly interpolated from the addresses in the "line" data from the street centerline file.  Consequently, a lot of those addresses do not exist.

I tried to create an address locator with Parcels, and then RG the points.  Everytime i did this ArcMap crashed.  I'm assuming you can't use an address locator built with polygons to RG.

Any idea how i should go about doing this?  I have roughly 40,000 points that need a closest address.

Thanks,

Steve

BenjaminBauman · Answer

Yup, what Joe said. And be sure to select the second radio button when you're creating the spatial join.

JoeBorgione · Answer

There are no common fields between Parcels and Street Signs.  So i can't do a join.

My next step is to try a composite address locator built using a street centerline file and a parcel polygon.

After that it's an intern 😉

Emphasis on SPATIAL JOIN. GIS 101; point in polygon. That's how you'll get the polygon address onto the point location.

StevenRussell_Jr_ · Answer

There are no common fields between Parcels and Street Signs.  So i can't do a join.

My next step is to try a composite address locator built using a street centerline file and a parcel polygon.

After that it's an intern 😉What if you performed a spatial join of your points into the parcel polygons. No doubt you'll get multiple joins but from what you describe that's okay.

Hope this helps.