I'm sketching lines and points using snapping. When I finish the sketch to create the feature it moves, of doesn't snap. To the point where lines over extend or come up short of the spot that they were snapped to. I am at a 1:60 scale (feet).
In the first image, I have snapped to the point and the line features. When I finish the sketch the new line if visibly disconnected from either feature.
Snap tolerance is 3 pixels, I've tried at 15 and 50 pixels and it does the same each time. I have edited in an existing MXD and add the data to a new clean MXD. Same result.
