Rebuilding Network In Pro does not recognize newly added edge

Question

I am trying to add a new segment to a network, but after rebuilding the network I can not route along the segment. It shows up in the edges, but its not being recognized for routing. I have no problems with this in ArcMap, but Pro I can not get this to work. Any ideas? I posted an image below of two stops and what the route is trying to do, which is not correct. Thanks in advance!

melisahansen · Answer

I was finally able to get it to work, but it took extra steps compared to arcmap. The only way I was able to get it to  work, was to rebuild the network before even making any changes, make the edit, save the edit, then rebuild the network again. Thanks for your responses!

Melinda Morang · Answer

Unfortunately, this is difficult in ArcGIS Pro as we have not yet implemented (as of Pro 2.5) the Network Identify tool that was available in ArcMap. Honestly, the easiest way to check this right now is to open the network dataset in ArcMap and use Network Identify to click on the new street and check its attributes.  Network Identify should tell you the value of the street for each impedance and restriction attribute.  It should also provide you with a list of other edges and junctions to which it is connected (so you can verify connectivity).

melisahansen · Answer

Topology has been checked, so connectivity should not be a problem. I checked and there were no errors when building the network. Also, Elevation fields are all set properly.

How would you check if only a specific edge is restricted? All the attributes of the new line match the required attributes of the network, so I'm not sure what could be wrong or how to even check if its restricted.