Utility Network analyst will not trace with flag set- why?

Question

I have been using the utility network analyst to trace path and to find disconnected NHD streams in a HUC4. Recently, all possible choices for tracing a network in the Utility Network Analyst toolbar are not working. I can set a flag but no actions result when I click on the solve tool. I am working in 10.7

JeffreyWarren · Answer

I believe I figured it out.  Looks like when I installed 10.7 and then 10.8, the interactive selection method, by default, was set to 'select from current selection'.  I changed that to 'create new selection' and voila!  You can find that setting under your 'Selection' menu > 'Interactive Selection Method'.

Hope this helps

PatriciaHaggerty · Answer

I also cannot get a trace .to run, with either selection or display settings. I do not recall having this problem in the past

JeffreyWarren · Answer

I'm experiencing the same issue, but only when the results are set to 'selection'.  It works when I have the results output to a drawing.  But I cannot figure out how to export those results to a separate layer/shapefile.

SuqiHUANG_0-1648711495142.png

Palet.png

AzinSharaf_1-1610566047958.png

SuqiHUANG_1-1648711578310.png