curve problems

Question

I have a problem when drawing polygons when creating a curve. Sometimes, at the end of the curve, the line isn't smooth. There's a break, like the one in the image.
If I have a lot of data, I want to discover all the problems that are similar to the image. Is there a way to use attribute rules or any other method that I can easily discover instead of visually reviewing the edges?

Untitled.png

cadContents_arcmap.jpg

BillFox · Answer

the "old" Arc/Info coverage's Clean command

https://pro.arcgis.com/en/pro-app/latest/tool-reference/data-management/integrate.htm

Reference: @HagenProbsthain1 @MarcoBoeringa @JeniferBarnes

https://community.esri.com/t5/arcgis-pro-ideas/clean-geometry-like-clean-command-in-arcinfo/idi-p/932652

BillFox · Answer

are you using COGO?

maybe missing that "reverse" tangent curve

maybe it is a non-tangent curve

fillet tool https://pro.arcgis.com/en/pro-app/latest/help/editing/create-a-fillet-between-two-segments.htm

find dangles https://pro.arcgis.com/en/pro-app/latest/help/data/validating-data/find-dangles.htm

MErikReedAugusta · Answer

I also don't see a gap.  But I do see a kink, where the curve just isn't smooth.  That's likely going to be much harder to locate.  I don't personally know of any ways other than the good old "Mark I Eyeball" method, though someone here might have figured out a script to analyze the curves at all of the nodes of each polygon.  I can't imagine it'd be too efficient a script to run, though...