Getting a USA flood map layer to only show 1 state

Question

I am trying to get the USA Flood Hazard Areas to show only those in Texas. The attribute table does not have a state category where I could filter by state.

I tried to do analysis > overlay layers> and picked the USA Flood Hazard Areas and a Texas geographical boundary. After it ran, there's no results in the attribute table for the new layer.

Is there a better way to approach this?

RussRoberts · Answer

Are you using the imagery or the feature layer version?

One way you can solve this is by using blend modes in Map Viewer. Here is a sample I tossed together using the imagery version and I removed the not mapped values under layer styling:

I created this clipped area by have these three operational layers grouped in a group layer and in this order

Then on the TX_state layer I set the blend mode to destination Atop under the layer properties panel

and then you are set.

It will also work for the feature layer version. Here I applied a bloom and a drop shadow to the FL version to make it pop against the imagery layer.

ellieocean · Answer

No I did not. I will try that - thank you!

JimWooten · Answer

Did you try the "clip" tool?