Slope Calculation Not Loading?

Question

*Running ArcGIS Pro

1. I found a Bare Earth DEM to use as my Elevation Data to calculate slope

2. I went to tools and looked for Spatial Analyst (Slope)

3. Input Raster (DEM) Output (Slope1) Degree Geodesic

4. Where problem starts. When I press "Run" It will load for 3% ->5% then go back to 0% and say "Running"

I left it on for 20minutes and it had 0 progress. I tried switching to planar and no difference.

Any suggestions or anything that I am doing wrong? I checked before and this comp can run ArcGIS and is running Windows10.

Any help would be greatly appreciated!

danretired · Answer

my guess would be yes, but if you need slope, a raster resampled to a larger cell size would be better, or clip out a smaller area to test whether the data set/size is indeed the issue

BoWalker · Answer

Thank you for replying Dan!

I clipped out the State of RI to run the DEM. Is that too big? It is a 0.76 m Lidar image of the State if that makes a diff.

danretired · Answer

Did you clip out your area of interest or were you hoping for the slope for the whole Earth?  Raster size would be an obvious issue.