Exclude abandoned pipes on gas tracing??

Question

Some of our existing gas data have abandoned pipes connected to operating (active) pipes through a gas fitting (edge-junction-edge connectivity).

Is it possible to configure the utility network to exclude abandoned pipes when running pipe tracing?

Any response is highly appreciated!

PaulLeBlanc1 · Answer

These are just the default values from the subnetwork definition. When you are running a trace, you can override them.

If you need to add a new network attribute, you'll need to stop the service disable topology to modify that.

Pei-yuChen1 · Answer

Is there any tool allowing users to change or modify the configurations after the Utility Network have been created and published?

Thanks!

PaulLeBlanc1 · Answer

You can assign a network attribute on the field that stores the active state and then set up a condition barrier.

Here's what that looks like in the Gas Utility Network Configuration