Hello friends,
i have DEM created from lidar data....
and when i clicked on white zone "identify" - pixel value is 1051,143555
BUT
range says that max value is only 695,96.
Is there any solution for this? Thank you so much.
Hi, mr. Crawford,
I just found out that the problem is that in the range of altitudes (215-695) did not take into account the value where stretched value is 255
Hi SV,
It might be a comma because in Czech a comma is used instead of a decimal point. In your raw data is a comma or a decimal point? It might be ArcGIS set to your language that is causing the decimal comma to be shown instead of the decimal point.
Decimal mark - Wikipedia, the free encyclopedia
I know this does not help your original question, just trying to make sure that's not the issue.
Arthur Crawford
yes i am using stretched symbology, but units are in meters.....i found this...........can i just overwrite that "679" with "1069,31"?
it looks like you are using a stretched symbology perhaps and are the units supposed to be in feet or meters and I suspect you are using a comma as the decimal separator
Angemeldete Mitglieder können Beiträge verfassen, Updates folgen und mehr. Neu hier? Registriere ein kostenloses Konto.
Find useful guides, FAQs, and documents to help you navigate and make the most of Esri Community.
