Zielort festlegen Kann nicht eingerichtet werden

RajatChopra

<\/HEAD>Hallo,<\/SPAN>

Mein Problem mit arc hydro ist der erste Schritt, bei dem wir den Raster- und Vektorstandort einrichten müssen. Immer wenn ich das versuche und danach eine Funktion auf DEM ausführe, wie z.B. Fill SINK, erhalte ich einen COM-Fehler: - 10006 oder so ähnlich.<\/SPAN>
Könnte mir jemand helfen, den Zielort einzurichten, damit ich weiterarbeiten kann?<\/SPAN><\/BODY><\/HTML>

MarkBoucher

When I start a project, I open a new mxd, load in a base layer with the coordinate system I want and save it. Then I load the dem and agreestream layers as well as inner and outer wall layers I will use.

At this point, when I perform the Arc Hydro tasks, the target locations are automatically set. If I move the mxd and layers to another folder then I need to reset the target locations. (I now do my work on my C: drive, off the network, because I don't get as many errors.) The dem, agree streams and wall layers are the basis of the Arc Hydro work. (There could be others that I don't typically use like lakes/water bodies.) If these are the same, the results should be the same.

So there have been a few times where I've had problems with the target locations and simply started a new mxd added these basic layers and let Arc Hydro set the new target locations.

I found an old thread where the solution included renaming the normal.mxd and letting Arc Map create a new normal.mxd. http://forums.arcgis.com/threads/16059-Setting-Target-Locations-ArcCatalog.

I just posted some guidlines on target locations to see if others agree on my understanding. You can find there at this link.
http://forums.arcgis.com/threads/84833-Setting-Target-Locations