Raster to Point Output: Points On Edge of Cells, Not Centered

jfeddings

Hello,

The Raster to Point tool embedded within my model  is outputting points on the edge of the raster cells rather then in the center, resulting in model outputs that are spotty.  I attempted running the conversion tool outside of the model and continue to get the same result.  I thought their might be something in the Environment Settings but can't figure out what it is.  Previously, the model ran seamlessly so I don't what has changed to make the tool function like this.  Thanks!

-Justin

Raster to Point Error.jpg

AustinAverill_0-1758020924756.png

jfeddings

After some further adjustments within the model Environment Settings, I switched the processing extent to Default rather than the extent of the area polygon that the rasters are clipped within.  This has centered the points on their raster rather then on the edge.

Hello,

The Raster to Point tool embedded within my model  is outputting points on the edge of the raster cells rather then in the center, resulting in model outputs that are spotty.  I attempted running the conversion tool outside of the model and continue to get the same result.  I thought their might be something in the Environment Settings but can't figure out what it is.  Previously, the model ran seamlessly so I don't what has changed to make the tool function like this.  Thanks!

-Justin