Attribute Assistant - Tabulka dynamických hodnot

Question

<\/HEAD>Minulý týden jsem upgradoval svůj počítač na ArcGIS 10.4.1 a stáhl nejnovější verzi Attribute Assistant z webu ESRI.<\/P> Attribute Assistant máme nakonfigurovaný přibližně 3,5 roku tak, že pokud je zadáno nebo změněno streetname id pro adresní bod, pole FullStreetname se vyplní pomocí Copy Linked Record a naší tabulky Streetnames, a zároveň tato změna (streetnameid) spustí také spojení Full Address.<\/P> Nyní jsem si všiml, že od upgradu, pokud změním Streetname ID u záznamu, FullStreetname se změní, ale Full Address se již nezmění. Zdá se také, že používá streetnameid z posledního pole hodnot. Nicméně, pokud ručně spustím Change Rules, Full Address se spojí pomocí aktualizovaného FullStreetname.<\/P> Zkoušel jsem měnit váhy pravidel, ale zdá se, že to nemá vliv. Níže je screenshot naší tabulky DynamicValue ve vztahu k našim adresním bodům.<\/P> <\/P> <\/P> <\/P> Jen se ptám, jestli se něco nezměnilo v nejnovější verzi?<\/P><\/BODY><\/HTML>

ChrisRumig1 · Answer

This is going to sound bizarre, so I edited the Loaded Config file, saved it, closed ArcMap, restarted it and the Attribute Assistant Add-In wasn't there so I re-installed it.  When I did that the toolbar appeared different than it had before (it now had the green square instead of the Green Exclamation that was in earlier versions. So when I tried editing and changed the Streetname ID the change event worked on the Full Address.

I have no idea why the old toolbar was loading (perhaps it was the mxd) as I deleted the old version of the Add-in when I downloaded the new version.  I guess rather than reading the Loaded Config file that's now in the ArcGISSolutions folder it was hanging onto the Loaded Config file in the ArcGIS4LocalGovernment folder (which is where I believe it used to be).

Chris Fox · Answer

Chris,

Could you try enable debugging and sharing the debug log? Below is a link to a help topic that describes how to modify the attribute assistant config file. You will want to enable the log and specify the log location. Then launch ArcMap change the Streetname ID and then close ArcMap and the operation should be written to the log file.

Configure Attribute Assistant - Attribute Assistant | ArcGIS Solutions

ChrisRumig1 · Answer

Hi Chris,

I've changed the rule weights but it still has the same effect.  When I enter the new Streetname ID and hit tab or use the mouse to move to the next attribute in the Attributes window the FullAddress does not concantenate.  It does though if I change a value in one of the other fields or run the Change Rules manually.