Configuring popups

Question

Hello,

I have a question about configuring popups.

I'm been asked to configure a popup to show all the fields in it's attribute table. I have completed this task, but will I need to republish the layer for the newly configured popups to show up? Or I can make the popup changes within the project, save it, and when a user clicks on a symbology with the newly configured popup, all the additional fields will be shown?

Thanks!

GIS412 · Answer

Thank you!

Eugene_Adkins · Answer

If your service was originally published with all the fields marked as viewable but afterwards you restricted the viewable fields on the published service side, you can make your previously hidden fields viewable in the configure pop-ups control … but if your service was originally published with viewable field restrictions (i.e. not all the fields were marked viewable), then you will need to republish your service.