Power Automate: Vytvořit nový záznam ve feature layer

Question

Všichni, <\/P> Používám Power Automate, abych pomohl automatizovat část pracovního postupu projektu. Bohužel narážím na problémy a můj Flow selhává. <\/P> Cíl je následující: uživatel aktualizuje atribut v ArcOnline hostované feature layer. Když se tento atribut změní na určitou hodnotu, potřebujeme, aby byl tento prvek (polygon a některé atributy) zkopírován do jiné hostované feature layer.<\/P> Přiložil jsem snímky obrazovky mého aktuálního Flow, ale mám problémy s tím, aby se polygon zkopíroval. Můžu zkopírovat atributy: co se stane, je, že je vytvořen záznam s atributy, ale není k němu přidružena žádná geometrie. Myslím, že to všechno souvisí s atributem "Geometry" v "Create a record in a feature layer," ale nemohu přijít na to, co tam vložit. Zkoušel jsem různé kombinace. Co dělám špatně? Ještě jedna poznámka: zatím jsem nepřidal podmínkovou část Flow, která identifikuje atribut a hodnotu, která by měla spustit kopírování záznamu (nejdříve chci, aby fungovalo kopírování geometrie!).<\/P> @SeanKMcGinnis<\/a> <\/P> @AnthonyLatini<\/a> <\/P>

AnninaRupe1 · Answer

@VivianPham, I think there may be some type of bug going on here. I found another post from a user that was having similar issues. The Fed UC is this week so it's likely Esri employees are pretty busy and haven't had time to respond. Hopefully something can get figured out!

VivianPham · Answer

I'm also having trouble with this particular flow with the "Geometry" attribute in the "Create a record in a feature layer". I've tried various methods, and the one above by AnninaRupe1 just isn't suited for me as I'm trying to create a record in a feature layer when a Sharepoint List Item is created. A quick chatgpt indicates trying this, but obviously no luck. "x": , "y": , "spatialReference": { "wkid": 4326

AnninaRupe1 · Answer

Following up on this with an update:

I found some documentation about the Geometry attribute and found out to find this attribute you have to type in "geometry" in the search bar in the Dynamic content window. After trial and error, I found a flow that partially worked: using the trigger "When a record is updated in a feature layer," run the "Get data from feature layer action." After that, run the "Fetch updates, changes, or deletions from feature layer" action and then run the "Create a record in a feature layer" action. The geometry gets written to the feature layer however it creates a polygon for each record in the original feature layer (not just the updated one) and the attributes are incorrect (the attribute is populated with the same value across each record, even those that are different). I have gotten just one record to be written (with the correct attribute) but in that flow there is no geometry associated with the record.