Sledování Fiber Cable a z vrcholů

Question

Ahoj všichni.<\/P> Implementujeme UN Telco v kontextu letiště (venkovní a vnitřní síť) a testujeme některé funkce v Chicago Dataset. Všimli jsme si, že když kreslíme nový kabel procházející existující 3D strukturou, mezilehlé vrcholy mají z = 0, i když je vrchol blízko handhole s přiřazeným z.<\/P> Toto je 2D pohled<\/P> <\/span><\/P>a toto je 3D pohled (v řezu) stejného kabelu... s vrcholy na z = 0<\/P><\/span><\/P>Existuje způsob, jak použít z struktur? Možná úpravou Attribute Rule "Line - Connection Point At Vertex"?<\/P> <\/span><\/P>To je zvláště důležité pro indoor network.<\/P>díky předem! Damiano<\/P> <\/P>

JohnAlsup · Answer

It is difficult to know just looking at the picture, but if we assume there is only one cable, then the attribute rule we provided will not change the Z value of the cable.  The attribute rule is not designed to set the Z's of cables based on a Structure Junction's Z value. It may be easier for us to communicate directly.  My contact email address is jalsup@esri.com

DamianoMontrasio · Answer

hi @JohnAlsup first of all thanks for your interesting.

Sorry but I don't understand very well your response.

You write: "the Attribute Rule you pointed out is designed to set the Z of the cable", but my problem it's exactly that the Z of the cable is not set, also if it's created a connection Point.

Also: cable is near structure for containment associations, but is not coincident with structure.

Can you help me understand it better?

Thanks!

JohnAlsup · Answer

Since two cables cannot exist in the same x,y,z, the Attribute Rule you pointed out is designed to set the Z of the cable to ensure there is no topological conflict.  However, in our case this may not be the behavior you desire.  If so, you can remove/dispable/delete the attribute rule.  However, you will need to ensure the cables are not all occupying the same x,y,z.