Select to view content in your preferred language

Shapefile Projection

1967
17
03-13-2017 04:23 PM
ABDALLAMOHAMED
Frequent Contributor

Hello.

 I have 100 US. metro cities in shapefiles  and would like to project them. I would like to know the most suitable projection type for them. Currently they are in Geographic Coordinate System: GCS_North_American_1983
Datum: D_North_American_1983.

Thanks a a lot

0 Kudos
17 Replies
DanPatterson_Retired
MVP Emeritus

Currently on PRO, but it is the same for ArcMap.

What is the best, depends on your spatial area coverage.  You can begin your journey in many ways, but I find the interface from ArcToolbox the easiest to remember

do some reading, start with what is used in your area, or by the federal gov't etc.  There are lots of choices lambert's and Albers variants tend to be recommended depending whether your E/W extent is wider than your N/S.

Others will weigh in with opinions, the above guides you to the 'where are'

ABDALLAMOHAMED
Frequent Contributor

Dan,

Let me check them, and let you know which one works

Thanks a lot

0 Kudos
DanPatterson_Retired
MVP Emeritus

remember, that the continental scale ones are best for a well spread out set of data... if all your points are on one coast or the other, then you might begin to examine those at a more regional level or even State-based.  Good luck... but do check what is used by the various levels of government.  Here in Canada, they are pretty specific as to what they use on a country and province wide basis

ABDALLAMOHAMED
Frequent Contributor

They are in polygons, and I selected two metro cities from each state. So they represent the 50 US states. Currently I'm reading an article talking about UTM is the best one.

0 Kudos
RebeccaStrauch__GISP
MVP Emeritus

UTM would NOT be a good choice is you are showing across the 50 states.

0 Kudos
ABDALLAMOHAMED
Frequent Contributor

Some of metro cities are across states like chicago, kansas and St Louis. I want to project each city separately

0 Kudos
RebeccaStrauch__GISP
MVP Emeritus

I want to project each city separately

then it might be ok.  you would just have to figure out the best UTM zone for each.  Like any projection, you will get distortion in one form or another. 

ABDALLAMOHAMED
Frequent Contributor

Can you give more explanation on UTM, I never use it before  and don't how to

0 Kudos
RebeccaStrauch__GISP
MVP Emeritus

I think the help would explain better than I ever could

What are projected coordinate systems?—Help | ArcGIS Desktop 

But in short, there are 60 UTM zones, each representing  6° (i.e. 60 x 6 = 360°).  so it is typically used for projects with smaller footprints.