How to add data from Arcmap 10.4 to Arcpad 10

1556
1
07-07-2016 02:57 PM
Highlighted
New Contributor

I have a dell tablet with Arcpad 10 on it, and have been trying to create a baselayer of NAIP imagery for mapping weeds.  I am using a Garmin glo bluetooth GPS connected to it.  When I open the NAIP imagery in Arcpad it shows up fine until I turn the GPS on.  Once the GPS is on the imagery disappears and I am left with a white map and just the gps location.  I matched up the projections from my imagery in Arcgis to the projection on Arcpad.  Any insight on how to approach this problem would be greatly appreciated.

Reply
0 Kudos
1 Reply
Highlighted
MVP Esteemed Contributor

how did you line them up? did you have to use the Project tool?  Hopefully you didn't use the Define Projection tool

Reply
0 Kudos