Can't use any search with an Address Locator I create

2132
0
11-24-2015 12:04 PM
EricHeinrichs
Occasional Contributor

I have been playing around with geocoding the past little while, and I am pretty sure I have set everything up right, but whenever I try to search for an address and see where it would be on my map, it always tells me that nothing is found.

 

When I browse through with the Address Inspector tool, it show what address should be at that exact point. But, I want to use the search function to input any address, so that it can show me where it should be.

 

The labelling is all pretty basic (it's a rural area, so all the roads are just mile roads ("Road 23W"), and the addresses are 4-6 digit numbers based on how far they are from the next mile road), so I didn't think it would cause this much of a headache.

 

Any help would be greatly appreciated!

Thanks!

0 Kudos
0 Replies