Snap Pour Point Tool stuck at 100

[SeanWillis]

Hello,

I am currently trying to snap a pour point to a stream gauge point to delineate a watershed. I have a flow accumulation raster that seems all fine but when I used that and the gauge, the snap pour point tool just gets stuck at 100 percent forever (or at least 30 minutes when I gave up on the process). I am just snapping a single point, so I should not be overwhelming the tool. Is there any possible fix? I have not adjusted any environment settings just the parameters as so:

[SantiagoVictoriaSierra]

Hello, I'm having the same problem. Did you solve it?