Re-solving only selected features

387
1
09-05-2013 11:52 AM
JoeRagno
New Contributor
Hi there,

I'm new to the game, so forgive me if this question has a no-brainer answer.

I'm doing service area analysis for 178 points.  If, of these points, two drop out of the solver as "non-traverseable" for example, is there a way for me to re-run just these two after adjustment rather than the entire set of 178 points again?  This is obviously just in the interest of saving time.

Thank you in advance for your assistance!

J.R.
Tags (2)
0 Kudos
1 Reply
JaySandhu
Esri Regular Contributor
The solve will solve for all facilities not selected ones. If you have two that need to be resolved, and you wanted to default overlapping service areas then you can create (or copy) a new service area layer, load those two unsolved facilities into it and re-solve.

Jay Sandhu
0 Kudos