I have a Trimble R1 that we have been using on an iphone and ipad with collector for a while with no issues. I have recently got some new tablets with Windows 10 and every time we try to connect the R1 it says 'connection failed' . Has anyone been able to connect the Trimble R1 to Collector on Windows 10?
It should work. check out my video How to setup a Trimble R1 outputing NMEA data to Windows 10 tablet - YouTube
I had the same issue today and was going to add the response below, but I just got it to work. For me, I went into the GNSS Status app and re-applied the NMEA settings (all) to SPP1, even though this had been done previously and they were all showing on the 'Selected' side. Once I applied them to the receiver, I was able to switch the location provider to the R1.
--------------------------------------------------------------------------------------------------------------------------------------------------------
I had the exact same issue today. I had previously been able to use an R1 in Windows 10 when Collector was still in beta, but tried the latest release and am getting the same error message when I try to switch the location provider to the R1.
System details:
Troubleshooting steps:
I have Trimble's GNSS Status app installed on this PC and it is able to connect to the receiver and show me the estimated accuracy, correction, etc., so I think the connection between the receiver and the PC are fine.