Trimming buildings on an unlevel terrain

2061
3
Jump to solution
03-19-2013 01:29 AM
JussiViinikka1
New Contributor
Hello,

How would I go about having world-y extrusion if the initial shape is not level and so that the top of the extrusion would be level?
I imagine I would first extrude the initial shape and then trim it somehow horizontally to its lowest vertex. So I dont want the top of the extrusions to follow the shape of the underlying terrain (as they are now if I align the initial shapes to terrain and then extrude world.y) but rather be 100% horizontal.

-Jussi
0 Kudos
1 Solution

Accepted Solutions
MatthiasBuehler1
Frequent Contributor II
Lot -->     alignScopeToAxes(y)     LotAligned(scope.sy)  LotAligned(yDim) -->     extrude(world.y, 100)     split(yDim : BaseVolume | ~1 : NIL)



Ok ?

View solution in original post

0 Kudos
3 Replies
MatthiasBuehler1
Frequent Contributor II
Lot -->     alignScopeToAxes(y)     LotAligned(scope.sy)  LotAligned(yDim) -->     extrude(world.y, 100)     split(yDim : BaseVolume | ~1 : NIL)



Ok ?
0 Kudos
JussiViinikka1
New Contributor
Great, works now. Many thanks!

Umm... Where is the button to mark a thread question answered? :)
0 Kudos
MatthiasBuehler1
Frequent Contributor II
Check the attached image ..

Not sure if you see the same ..
0 Kudos