Field Calculator Raising a Field To a Power

Question

I'm trying to raise the value of a field to a power.  How do I go about doing this?  What is the prelogic VBA script? 
I notice the first 800 values where calculated correctly before error running VBA code pops up.  using the code below

36.89*([THICKNESS]^-0.3883)  Where am I going wrong?

*Update* The formula does not work when the value of Thickness = 0  causing the user interrupt error

RichardRupp · Answer

Could you first select the features with [Thickness] > 0, and then run your algorithm on the selected set?

ZacharyMetz · Answer

If thickness is allowed to = 0 then you end up with 0 raised to a negative power which is an undefined number.  You may have to set some rules/parameters to disallow thickness = 0.

What would be the correct pre-logic VB Script parameters to exclude 0?

WilliamClark · Answer

If thickness is allowed to = 0 then you end up with 0 raised to a negative power which is an undefined number.  You may have to set some rules/parameters to disallow thickness = 0.