ndemiranda-esri-ca-esridist

Running an ETL Tool Straight From ArcToolbox

Discussion created by ndemiranda-esri-ca-esridist on Sep 15, 2010
Latest reply on Feb 22, 2012 by danielchaboya
I've created a series of Spatial ETL Tools to migrate a various amount of data and information.

However, I run into a problem when I double click the tool and fiill the parameters in the GUI.
An error message is presented (see attached).

Note: I am using ArcGIS 10 ArcInfo Lic.

In order to troubleshoot I've done the following:

1) Ran the ETL Tool within the FME Workbench Software - This works.
2) Ran the ETL Tool embedded within a Model using Model Builder - This works.
3) Ran the ETL Tool alone without a model inside the ArcMap interface and - Bing Bang Boom - Error.

Also, I have not modified the filepaths.


Thanks in advance,

Attachments

Outcomes