nmmu_student

Point to Raster

Discussion created by nmmu_student on Jun 24, 2014
Latest reply on Jun 25, 2014 by nmmu_student
Hi, I am converting points to raster. I am using the Conversion tool, Point to Raster, and converting my points in batches. However, not all of my points are being converted e.g if I orginally had 7 points in a shapefile, only 3 are being displayed as raster cells after conversion. My cells size is the same for each conversion, and the cell size is set using a mask in the environments field.

Any thoughts on what steps I may be missing or what I should/should not be doing would be appreciated.

Thanks

Outcomes