infobleep

Offsetting line using representation not working and how do I select a feature below?

Discussion created by infobleep on Jun 10, 2013
Latest reply on Jun 10, 2013 by infobleep
Hi there

I am trying to offset a line using the representations toolbar. However whenever I enter in an offset, it simply reverts back to 0 and the line is not offset.

I can set a global offset in the symbology for the layer but that then offsets everything, rather than the single line I wish to offset.

I am using ArcMap 10sp4 and I am finding that when I use the select representation tool, I cannot select the representation below. Does anyone know how to do this?

Kind regards


Tim

Outcomes