rieckmannd

Closest Facility - Processing "Facilities"

Discussion created by rieckmannd on Nov 29, 2012
Latest reply on Nov 29, 2012 by jsandhu-esristaff
Hello,

I am working on a closest facility layer that uses about 7000 facilities.  I have tried using both the load locations tool and the Add Locations geoprocessing tool to add points into my facilities sublayer.  When I add in an incident location and hit solve it says "Processing "Facilities"" in the bottom left of the screen and it goes rather slowly through each facility before it will solve.  I have performed this same analysis in 9.3.1 and I never have seen that message and my solves go through fine.  Is there some way to help optimize the performance of the solve in 10.1 that I'm missing?

Outcomes