I have a script that runs some calculations on 5 input rasters. The input rasters are stored in a file geodatabase. I have the file geodatabase set as my workspace. The first round of calculations works fine, and four additional rasters are created within the file geodatabase. When I try to run the second round of calculations, using a con statement, on the newly created rasters, the script gives an error that says the rasters don't exist. The rasters do exist in the path shown in the error message. I have changed the script to create the new rasters outside of the file geodatabse, and this works without any problems. Is there anything I can do to get the script to recognize the rasters it creates within the file geodatabase?