Drawing polylines with specific angles

Discussion created by yaskshelat on May 7, 2012
Latest reply on May 7, 2012 by dlee-esristaff
I am a geologist, I have some drill hole data.

I would like to draw the direction of drillholes (collar) using the polylines.

Is it possible that I can draw polylines with specific angles i.e., 0 degrees (north) , 90 degrees, 75 degrees etc. This way a polyline would orient exactly the same way as the angle mentioned.

I tried to use direction/length option (this option comes when I right-click the polyline while drawing it) This option does not allow to choose the angle. I am not sure how to use this option properly. Please suggest.