jfailing

Showing Depth Points on Wellbore-Line

Discussion created by jfailing on Jan 26, 2012
Latest reply on Jan 26, 2012 by dlee-esristaff
I have a series of about 30 different well-bore shapefiles (lines).  My goal is to have points on these lines that represent the depths of the wellbore, every 1000 feet (above or below sea level).

Is there a function that can detect an intersection of a line through a plane with a Z value?  That way I could designate a Z value of say -2000 feet below sea level.  Each point that a well-bore line intersected that plane would represent that depth point... 

Is this possible?  Or will I have to do it manually?

Outcomes