Jamesnunn

Modelbuilder as a tool is not the same as running the same model in modelbuilder?

Discussion created by Jamesnunn on Jan 19, 2012
Latest reply on Jan 30, 2012 by Jamesnunn
Hi

I am having a very frustrating problem where I have created a model which is basically a spatial join with some layer creation. When the model is run inside modelbuilder, the result is as intended. If it is run as a tool (with parameters filled in correctly), the outputs are deleted/not created at all. Is there an intentional difference or is this a known bug? I am running ArcView 10 SP3.

Thanks

Outcomes