chris.blinn799

Missing Output from Geoprocess

Discussion created by chris.blinn799 on Apr 21, 2011
Latest reply on Apr 22, 2011 by Dan_Patterson
Hello All,

This is all being done in ArcGIS 10.0.  I have ran a Weighted Sum for 6000+ rasters.  The process only takes roughly 4-5 minutes and the Results window states the process has succeeded and the output raster was created.  There are no error or warning messages throughout or at the end of the process.  However, the output raster is not showing up in the file location, or anywhere else for that matter.  I have searched the entire computer for the file and it is no where.  Any suggestions on what may be going wrong?  I am using Weighted Sum but the weights for all rasters are 1, and the values for the cells are either 0 or 1.  The rasters are quite large; roughly the size of the continental US, with a 1 mile by 1 mile resolution (I am aggregated my results if I ever get a file from the Weighted Sum process).  Any ideas would be helpful.  Thank you in advance!

Chris

Outcomes