AnsweredAssumed Answered

How to input this legal description into ArcMap using COGO tool?

Question asked by ibroad on Nov 20, 2019

I have a legal description that I need to create in ArcMap, and I'm not certain how to input some of the descriptions.

 

Here are a couple of the descriptions I need to input:

 

If I only input the part that states:

 "...the chord of which bears North 47° 52' 22" West 88.90 feet to a point of reverse curve"

From each section and leave out:

"...thence 90.89 feet along the arc of a 125.00 radius curve to the left"

Then it roughly follows the correct path with a straight line, but it should be slightly curved.

 

I believe each section is describing a single curved line, but there are 4 parameters, and with the COGO tool, the most I can enter for a curve is three!

 

So, for the underlined blue and green descriptions in the above image, if I enter these, then it does create straight line segments that roughly follow the path:

 

Blue:

 

Green:

 

But how do I add the

"...thence 90.89 feet along the arc of a 125.00 radius curve to the left"

So that it creates the curved line?

Outcomes