AnsweredAssumed Answered

Anyway to retroactively get z values in attribute table?

Question asked by adam_KYRCAP on Oct 8, 2019

I use a Trimble R2 unit to collect GPS locations with ArcPad, and did not enable Z value when creating the feature classes. When post-processing the data, I saw the points did still gather elevation data; however, it does not appear in my attribute table when adding geometry attributes (only X and Y). 

 

So, I created a new feature and enabled Z value, then imported all the data from the other feature into this feature. Unfortunately, when using the tool "add geometry attributes" I got the same Z value for all the features. 

 

Is there anyway to retroactively get these Z values to appear in my attribute table? This is for over 1,000 features.

 

 

Thank you all. 

Outcomes