AnsweredAssumed Answered

Hello, I can't find a solution to this problem.

Question asked by cmoon_smygis on Mar 27, 2018
Latest reply on Mar 27, 2018 by Dan_Patterson

I have run a kernel density, used optimized hot spot analysis, collect events, etc. The results will say that an output was completed, but the output layer, raster, etc. does not show in my table of contents or in the designated workspace. Does anyone know what is going on? The only changes I made were reducing my points from 61000 to 8300 because I am wanting to analyze specific data. After I selected the data I wanted, I created a new layer. I exported the layer into a shapefile. Ran everything as normal and nothing is displaying. Under the results, next output surface or output anything it does NOT say empty. 

 

Any assistance would be greatly appreciated! 

Outcomes