Lady_Jane

BatchDone will not change to -1 on failed delineations

Discussion created by Lady_Jane on Jan 24, 2011
Hi everyone,
I am using Batch Subwatershed Delineation in ArcHydro.
Every time the delineation completes and I get a message saying x number of points have failed, the BatchDone field in the batch point attribute table is still populated completely with 1 (implying that all points were successfully delineated).
I was using Batch Watershed Delineation as well, and was accidentally trying to save the watersheds into a personal geodatabase that had exceeded its size limit.  Those errors returned a value of -1 in the attribute table, but that is the only time that feature has worked.

Has anyone else seen this?
Thank-you,

Outcomes