AnsweredAssumed Answered

Trace Geometric Network (FindPath) Edge vs. Junction Pts

Question asked by rsm_ddms on Apr 6, 2017

I am running a FindPath on two points. The two points have been snapped to the geometric network. One landed on a junction, one landed on an edge, apparently

I am getting the following error when I run Trace Geometric Network with the "FindPath" option

 

both junction and edge origins are specified for FindPath

 

I cannot prevent points from snapping to junctions, so how can I rid myself of this annoying error? I will do this a LOT, so it would be nice if I didn't have to futz around with the points to make sure none happen to land on junctions.

 

Is there a way to say "ignore junctions" or "treat junctions as edges"

 

Thank you very much,

 

Randy McGregor

Outcomes