AnsweredAssumed Answered

"locate feature along routes" tool stops working for routes longer than 215 km

Question asked by guyuananne on Oct 19, 2016
Latest reply on Nov 10, 2016 by guyuananne

Hello. I'm trying to identify roads along routes in the country road network of Cote d Ivoire. The "locate feature along routes" tool works perfectly well for routes shorter than 215 kilometres. However once the routes gets longer than 215 kilometres, the tool only produce an empty event table without error message. 

 

I have tried several ways to pin down the problem. 

 

a, The first suspicion is that too many routes have been put into calculation at the same time. But it is not the case. Even though only one route is chosen, the tool gives empty table as long as the route is longer than 215 km.

 

b, A second thought is that too many inputs rows have been put into calculation. It is not the reason either. I changed input from polylines to polygons which represent administrative district. The chosen route should have only penetrated a few districts. There is still no result produced.

 

To illustrate the problem, some screenshot are pasted below:

 

"Locate feature along routes" tool works well for shorter routes. It can be observed that the maximum route length never exceeds 215 km after several tries.

 

If one long route is chosen:

 

No result will be produced in the output event table.

 

I am trapped here for a few days and couldn't find solutions from ArcGIS website or posts in the forum. It seems that no one has a similar problem of length limit in routes. I'm using ArcMap 10.4.1 with 8G roaming. Any tip is most welcomed. Thank you!

Outcomes