antstella

IMPORTING AND TRASFORM CAD DATA

Discussion created by antstella on Dec 14, 2010
Latest reply on Dec 22, 2010 by hpbrantley
at your knowledge could be possible to implement this operation below?
actually I have more than 500 cad file (DWG with same structure) for each could be:
1) more of this are 3d (with Z value) and other 2d (without Z), actually the only possibility is to open file and determine this; i need to convert only polilyne 3d to 2d
2) extract 2 layers for each 2d
3) convert projection from Monte_Mario_Italy_2 to WGS_1984_UTM_Zone_33N

It could be possible with Model Builder?
thank for all information you can give me
Cheers Mirco

Outcomes