AnsweredAssumed Answered

Arc GIS Pro 1.3 labeling problem

Question asked by sraretail on Jul 12, 2016
Latest reply on Feb 10, 2017 by MidnightYell2003

Good Morning,

 

I updated to ArcGIS Pro 1.3 and am now having issues with drawing any layer that has a label.  I tested my state boundaries layer as the only layer visible (which should place about 12 labels) and after 3 minutes the labels still didn't draw.  It also utilizes a good amount of my CPU during the process, which instantly goes down as soon as I stop the layer from drawing.

 

The geography draws fine, but when it gets to the point of placing labels I get that spinning circle at the lower right hand side of the map window.  I went into a 20 minute meeting and the layer finally drew, but I know that Pro 1.2 could label this in a few seconds.

 

Any thoughts?  I'm waiting to get through to ESRI support.

Outcomes