I have been using the reclassify raster tool with no trouble until today when I noticed the output would display certain areas as "NoData" even though the original raster did have data values that were part of the reclassification range. Has anyone else had this issue and how did you get around it?
does your reclassification scheme include all possible values? if not, you will end up with nodata. You could show the before and after classes
Think I may have resolved this. I entered a lower value than the one that was not being reclassified and it finally displayed correctly in the output.
yes, that is what I meant, your reclassification scheme must be inclusive... ie includes all possible values. think of it as binary 1 its in, 0 its not
Ok. That makes more sense then. Thank you.
Retrieving data ...