AnsweredAssumed Answered

snapping not working correctly

Question asked by brettcase on Feb 26, 2016
Latest reply on Feb 26, 2016 by brettcase

trying to snap a water line to valve and hydrant points. I have my snapping tolerance set to 10. I have my snapping tool set to points. when I hover over the point the popup correctly says that I am snapping to the point I want. in the sketch it shows the line snapped to the point, however when I click "finish sketch" the line moves away from the point. It was doing this in 10.3 so installed 10.4 hoping to fix it but it still does the same thing. any ideas?