AnsweredAssumed Answered

How do I join lines end-to-end

Question asked by johnwarden on Jun 26, 2015
Latest reply on Jun 27, 2015 by johnwarden

I am using lat/lon coordinates to map points, then using the "Points to Line" tool to connect the points into a line, such as a road. The lat/lon coordinates are being generated separately for each county in the U.S.. Where the resulting lines are supposed to meet at the county boundary there is a small gap. The attached map illustrates the problem.


I have the same small gap where lines are supposed to join together within a county, which is also illustrated in the attachment.


Bearing in mind I will have thousands of instances where line pairs need to be joined, is there a way to do this with a few commands, or perhaps with a custom tool built in Modelbuilder.


If it helps, the line ends that need to be joined will always be very close together to begin with, they just won't be touching, so any procedure that involves performing an action based on proximity would probably work.