reimari

Spatial reference changes itself?

Discussion created by reimari on Mar 3, 2014
Latest reply on Mar 5, 2014 by MKennedy-esristaff
Hello,

I'm running model builder as follows:
[ATTACH=CONFIG]31917[/ATTACH]

Input and snap raster are both in EUREF TM35 FIN coordinate system. But everytime I run this, the output
is in ETRS89_1989_Transverse_Mercator (which is almost the same), but anyhow, why on earth does it change?

I tried empty workspaces, clean .mxd, clean model builder. Everything. I set spatial reference everywhere in to EUREF FIN, but some how the output is in different spatial refence.

Bug??

Attachments

Outcomes